Enabling CDR Generation and Configuring CDR Server Address

For the device to generate CDRs, you need to enable the Syslog feature and configure a collecting server address. The collecting server can be a dedicated CDR server or the server used for Syslog messages.

➢ To enable CDR generation and configure the CDR server address:
1. Enable the Syslog feature (see Enabling Syslog).
2. Open the Call Detail Record Settings page (Troubleshoot menu > Troubleshoot tab > Call Detail Record folder > Call Detail Record Settings).
3. In the 'CDR Syslog Server IP Address' [CDRSyslogServerIP] field, enter the IP address or FQDN of the server to where you want the CDRs sent.

4. Click Apply.
● If you do not configure an IP address for a CDR server, the device sends the CDRs to the address that you configured for the Syslog server (see Configuring the Primary Syslog Server Address).
● The port and transport protocol configured for the Syslog server is also used for the CDR server (see Configuring the Primary Syslog Server Address).